E-TECH Engine enamel is a high quality, long lasting, enamel coating specially formulated with a ceramic resin to cope with temperatures of up to 250C, and is suitable for use on most engine parts and components.

Ideal for engine blocks, valve/rocker covers and gearbox/differential casings, plus other engine bay components.

The spray-on application is simple to apply, quick drying and provides a hard, chip resistant, long lasting finish which will retain its colour due to the high pigment content.

Colours: Orange

Features

• Long lasting high quality finish
• Tough chip and crack resistant formula
• Resists oil, engine additives, chemicals, road salt & weathering
• Excellent durability
• No primer needed – strong adhesion to bare steel and metal*

SPECIFICATION

Can Size 400ml

It is aspray on application so quick drying and provides a hard, chip resistant, long lasting finish which retains its colour due to the high pigment content.

* Long term performance of this paint on aluminium and stainless steel surfaces cannot be guaranteed.

Not suitable for brass and other non-ferrous metals

Colours: Orange

INSTRUCTIONS

PREPERATION – IMPORTANT: READ THIS

• For best results ensure the engine or part you are painting, and the paint are at room temperature before use (approx 17C to 21C)
• For best results apply in a warm, dry and dust free srea
• Use a steel brush to remove loose dirt and rust deposits from surface to be painted
• Then clean the area to be painted thoroughly with a degreaser or steam cleaner, removing all traces of silicone, oil, dirt, grease etc.
• Mask off any area that you do not want to be painted
• The area to be painted mst be completely dry and thoroughly clean before you start.

APPLICATION

• Shake can vigorously for a minimum of 2 minutes before use.
• Hold can 20-30cm (8-12″) from surface and spray using a smooth side to side motion.
• Build up layers with several thin coats allowing approximately 15-20 minutes between coats for the surface to dry to a tacky film (do not apply heavy coats).
• Shake can between coats
• After applying the final coat allow 4 hours for the enamel to dry properly.